Yamaha FZ-10 Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Just installed the quickshifter, but I can not get the ECU to recognixe it. I've held the shift lever up for 10, 20, even 30 seconds after turning the key on and nothing. Not sure what to try next. Any help would be appreciated.
 

·
Registered
Joined
·
306 Posts
Wish I could help, but when I had my ECU reflash done they did it for me before I even installed one. I'm sure some one will chime in soon.
 

·
Registered
Joined
·
56 Posts
It is a little tricky, I had to move the bike around (back and forth) before it finally liked when I shifted it and held it. I know it sounds weird but it worked for me..
 
  • Like
Reactions: Mz10mtl

·
Registered
Joined
·
2 Posts
Like rg1 said, sometimes you have to move forward/rear to work, i tried many times before it works for me
(You have to be on neutral, and when you pull up lever for 20seconds your dash gonna be on 2nd but not really ingeared on 2nd so when you realease the lever you'll return on Neutral and then the qs will show)
 
1 - 5 of 5 Posts
Top